SCHUBERTH SR1 Manual page 31

C. THE HELMET
CHANGING THE VISOR SHIELD
The visor shield can be changed easily and with the convenient
push-release system. It is helpful when changing the shield to
place the helmet on a fl at surface or on your lap.
Removing the visor shield
1. Close the visor. Press the button of
the push-release visor mechanism
on one side and hold it down.
2. Move the visor upwards until it is
released from its fi xing.
3. Repeat steps one and two above
on the opposite side of the visor.
Fitting a new visor shield
1. Using both hands, guide the catch
pins of the visor into the recess
provided for them in the visor
mechanism.
62
2. Apply light pressure directed
towards the helmet and a closing
motion until the visor engages
audibly.
3. Check the functioning of the visor
mechanism by opening it until it
hits the end stop and then closing
it again.
SAFETY NOTICE
Check the functioning of the visor before every ride and ensure
that it offers adequate vision. Remove any dirt before each ride.
Check the visor for mechanical damage and cracks. Badly scratched
or dulled visors will affect vision and should be replaced before
riding for safety reasons.
Warning: Petrol, solvent and fuel vapours may lead to the
formation of cracks on the visor. Do not expose the visor to
these vapours. You should never place the helmet on the fuel
tank of your motorcycle.
63