Safety Instructions; General; Intended Use - Fronius Robacta TC 2000 ext. Operating Instructions Manual

Safety Instructions

General

Intended Use

The device has been manufactured using state-of-the-art technology and ac-
cording to recognized safety standards. If used incorrectly or misused, howev-
er, it can cause
- injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operat-
ing company,
- inefficient operation of the device.
All persons involved in the commissioning, operation, maintenance, and ser-
vicing of the device must
- be suitably qualified,
- have knowledge of automated welding and
- have read these Operating Instructions and any system component oper-
ating instructions in full and follow them carefully.
The Operating Instructions must always be at hand wherever the device is be-
ing used. In addition to the Operating Instructions, all applicable local rules
and regulations regarding accident prevention and environmental protection
must also be followed.
All safety and danger notices on the device must
- must be kept in a legible state
- not be damaged/marked
- not be removed
- not be covered, pasted, or painted over
For the location of the safety and danger notices on the device, refer to the
section headed "General" in the Operating Instructions for the device.
Before switching on the device, remove any faults that could compromise
safety.
Your personal safety is at stake!
The device is to be used exclusively for its intended purpose.
The device is intended exclusively for the electromagnetic cleaning of Fronius
welding torches.
Utilization for any other purpose, or in any other manner, shall be deemed to
be "not in accordance with the intended purpose." The manufacturer is not re-
sponsible for any damage resulting from improper use.
Proper use also means
- Reading and adhering to all instructions in the operating instructions
- Reading and adhering to all safety instructions and danger notices
- Carrying out all the specified inspection and servicing work
The device is designed for operation in industry and business. The manufac-
turer shall not be liable for any damage resulting from use in a living area.
The manufacturer shall also not be liable for faulty or incorrect work results.
7