Service, Maintenance And Disposal; Before Every Start-Up; Daily; Weekly - Fronius Robacta TC 2000 ext. Operating Instructions Manual

Service, maintenance and disposal

Before Every
1
Start-up

Daily

1

Weekly

1
2
3
4
5

Every Six Months

1

Every 12 Months

1
Clean the intake
filter in the part-
ing agent contain-
er
Check the fill level in the 'Robacta Reamer' parting agent container and top up if nec-
essary
NOTE! Only clean the devices with cleaning products that are free of solvents.
Remove any deposited parting agent and contamination from the outside of the base
unit and cleaning unit.
Empty the cleaning unit's welding residue collecting container
Clean the inside of the cleaning unit's cleaning aperture
Check the 'Robacta Reamer' parting agent container for contamination and clean if
necessary
Blow out the intake filter in the 'Robacta Reamer' parting agent container from the in-
side out with compressed air using the intake hose (see section
ter in the parting agent container
If present, check the condition of the brush seal above the cleaning aperture. If the
brush seal is worn out, replace it
NOTE! Do not blow electronic parts clean from a short distance away.
Open the base unit and cleaning unit and blow clean with dry and reduced com-
pressed air
Have a Fronius service technician perform a safety inspection on the cleaning device
NOTE! Only use the 'Robacta Reamer' parting agent provided by the manufac-
turer. Its composition is specifically tailored for use with the Robacta TC. Correct
operation is not ensured when other products are used.
starting on page 59)
Clean the intake fil-
59