Emc Measures; Safety Measures At The Setup Location And During Transport - Fronius Robacta TC 2000 ext. Operating Instructions Manual

EMC Measures

Safety Measures
at the Setup Loca-
tion and During
Transport
WARNING! Electromagnetic field! Electromagnetic fields may cause health
problems that are not yet known.
It is the operating company's responsibility to ensure that there is no electro-
magnetic interference with electrical and electronic equipment.
If electromagnetic interference is detected, the operating company is obliged
to take measures to rectify the situation.
Check and evaluate possible problems and the interference immunity of
equipment in the vicinity according to national and international regulations:
- Safety devices
- Grid power lines, signal lines and data transfer lines
- IT and telecommunications equipment
- Devices for measuring and calibrating
- The health of persons close by
Supporting measures to avoid EMC problems:
1. Grid power supply
- If electromagnetic interference occurs despite a grid connection that
complies with regulations, take additional measures (e.g., use a suit-
able grid filter).
2. Shield, if necessary
- Shield other devices in the vicinity
- Shield the entire welding installation
3. Do not carry magnetic or electronic data carriers:
Magnetic or electronic data carriers can be damaged due to the magnetic
fields occurring during operation of the device.
4. Do not carry watches or pieces of metal. Watches may be damaged by
the operation of the device.
A toppling device can be deadly! Set up the device securely on an even, solid
surface
- A tilt angle of no more than 10° is permitted.
Special regulations apply in areas at risk of fire or explosion
- Follow the appropriate national and international regulations.
11