Table of Contents
Advertisement
Maintenance and
repair
Safety Inspection
Disposal
It is impossible to guarantee that bought-in parts are designed and manufac-
tured to meet the demands made of them, or that they satisfy safety require-
ments.
-
Use only original spare and wearing parts (also applies to standard parts).
-
Do not carry out any modifications, alterations, etc. to the device without
the manufacturer's consent.
-
Components that are not in perfect condition must be replaced immedi-
ately.
-
When ordering, please give the exact designation and part number as
shown in the spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing the
housing parts.
Only use original housing screws in the correct number and tightened to the
specified torque.
The manufacturer recommends that a safety inspection of the device be per-
formed at least every 12 months.
A safety inspection by a certified electrician is recommended:
-
after changes
-
after alterations
-
after repair, care, and maintenance
-
at least every 12 months.
For the safety inspection, follow the appropriate national and international stan-
dards and guidelines.
You can obtain more information about the safety inspection and calibration from
your service center. The service center will provide the necessary documents
upon request.
Do not dispose of this device with normal domestic waste! To comply with the
European Directive on Waste Electrical and Electronic Equipment and its im-
plementation as national law, electrical equipment that has reached the end of
its life must be collected separately and returned to an approved recycling fa-
cility. Any device that you no longer require must be returned to your dealer,
or you must locate the approved collection and recycling facilities in your area.
Ignoring this European Directive may have potentially adverse affects on the
environment and your health!
13
Advertisement
Table of Contents
Troubleshooting
