Start Up The Cleaning Device; General; Requirements For Commissioning - Fronius Robacta TC 2000 ext. Operating Instructions Manual

Welding torch cleaning

Hide thumbs Also See for Robacta TC 2000 ext.:

Table of Contents

Start up the Cleaning Device

To achieve optimum cleaning results, observe the following points:

Requirements for

The following requirements must be met in order to commission the cleaning device:

Commissioning

Only if present/used

NOTE! If wetting agent has not been applied to the inside of the welding torch,

this may lead to the permanent contamination of the welding torch when welding

begins. Always wet the inside of the welding torch with the manufacturer's 'Ro-

bacta Reamer' parting agent before starting an automatic mode.

Always wet the inside of the welding torch with parting agent

Adhere to the specified cleaning procedures

Adhere to the specified cleaning positions

Blow out the welding torch with compressed air during cleaning (but not while parting

agent is being injected into the inside of the welding torch)

NOTE! Individual small spatters are not removed by the cleaning device. Small

welding spatters do not, however, affect the welding process.

Base unit screwed tightly to the surface

Cleaning unit screwed tightly to the surface

Interconnecting hosepack of cleaning unit connected to the base unit

Base unit connected to the grid

Base unit supplied with compressed air

Base unit connected to the robot control

'Robacta Reamer' parting agent container connected to the cleaning unit

Wire cutter installed and supplied with compressed air

Table of Contents