Adjusting The Belt - Kellfri 35-VKM195H Manual

ADJUSTING THE BELT

Release the fastening bolts for the gearbox and pulley
(see figure). Then adjust the adjusting bolt until the belts
are tight enough.
CHECK AND TIGHTEN THE BELTS AFTER 2 HOURS OF OPERATION! THIS IS IMPORTANT IN
PARTICULAR WHEN OPERATING THE MACHINE FOR THE FIRST TIME!
FASTENING BOLTS
ADJUSTING BOLT
Bolts must be retighten at regular intervals.
To hold the sleeve in place when changing the belt
or pulley:
* Loosen and disassemble 3 bolts from the pulley.
* Fit them into threaded holes on the sleeve
(see marked holes in the picture).
* Then remove remaining bolts.
* Replace belt/pulley and then assemble all bolts.
* Tighten and check belt tension, adjust if necessary.
Table of contents
15