Table of Contents
Advertisement
DRIVE AND SPEED
The amount of grass to be cut determines the speed forward; low speed usually gives the best
results. Start with the lowest possible speed, ensure that the strimmer is working effectively
with the tractor at maximum speed without effort.
It is important to always listen to the engine to ensure that the engine and machine functions
effectively, slow down or stop if the motor starts to go heavy. Expected rate is much lower
during hard work.
Adjusting the cutting head distance from the tractor
•
Always turn off the tractor engine before performing any adjustments on the machine
•
Set the machine on the ground, mount the outriggers
•
Remove the pin from the beam and pull or push the cutting head to adjust the distance
Reinstall the pin
RELIEF SPRING (ANTI-BARRIER SYSTEMS)
Anti-barrier system allows the unit springs to jump when it hits an obstacle
•
The tension of the spring should be adjusted before cutting thick grass
•
When trimming densely vegetated area the spring shall be set on tense
AFTER USE
• Rinse of the machine if necessary
9
Advertisement
Table of Contents
