Maintenance And Service - Kellfri 35-VKM195H Manual

MAINTENANCE AND SERVICE

Make sure the implement is stable and there's no risk of falling over during maintenance and
service. Replace damaged and worn parts immediately to reduce the risk of machine failure
and injuries. Perform maintenance, service and inspections as recommended. Use only spare
parts with equivalent performance to reduce the risk of damage and failure.
Check that all bolts and nuts are tightened after maintenance and service. Always test the
machine before starting work.
RECYCLING
Dispose the product correctly, disassemble and transport to the municipality's
recycling station. Contact your local authority for further information.
SERVICE
Flails
Gearbox
Rotor
Belt
The machine
Lubrication
12
Dispose broken parts correctly when recycling.
INTERVAL
Before each run.
During operation.
After each run.
Before each run.
50 operating hours
100 operating hours or at
least once a year.
20:e operating hour
After 1 hour of driving.
Regularly.
After each run.
First time after 2 hours of
operation.
After 20 operating hours.
Table of contents
Important!
Replace all damaged flails. Sharp flails give
better results. When replacing bolts, tight-
en bolts properly.
Listen for unusual noise.
Check
Check the oil level:
Oil type: transmission oil 80W-90 (1,5L)
First oil change.
Oil change.
Grease in the tube
(amount/type): 0,2L/ 80w90
Lubrication.
Check and tighten the belt. At pressure the
belt should be moved 20 mm.
Rinse soil and grass with water.
Lubricate all grease fitting regularly.