Keysight PXA N9030A Installation Note page 6

Frequency Range Upgrade from RF or Microwave to Millimeter Wave Frequency
Quantity Description
1 W61, Cable, semi-rigid, YTF Output to Switch 4 Port 3
1 W62, Cable, semi-rigid, Switch 4 Port 2 to A13A1 J9
1 Connector Body for switch cable
1 A11 Low band Switch
1 Low Band Switch Bracket
1 A12, YTF Preselector
1 A12MP1 Gap Pad
1 A13 Front End assembly
1 A15 Front End Controller
19 Screw, M3 x 0.5, 8 mm long
15 Screw-Machine W/Crest-Cup-Con-Washer M2.5 x 0.45, 6 mm long
2 Screw-Machine 90-DEG-flat-HD M3 x 0.5, 8 mm long
1 Label, Frequency Upgrade, 44 GHz
1 Label, Frequency Upgrade, 50 GHz
1 Rear panel frequency range upgrade label, 544/ 44 GHz
1 Rear panel frequency range upgrade label, 550 / 50 GHz
Tools Required
— Personal computer with internet access and USB port
— LAN connection to instrument (allows factory to control unit)
— Disk drive re-initialization software.
— USB storage device with > 2 GB free memory
— USB mouse and keyboard
— T-10 TORX Driver
— T-20 TORX Driver
— 5/16-inch torque wrench
— 1/4-inch open end wrench
— Keysight Calibration and Adjustment Software, N7814A (revision E.12.00 or later)
— Test equipment + computer supported by the Keysight Calibration and Adjustment Software
— PXA Signal Analyzer Service Guide.
6
Part Number
N9020-20129
N9020-20130
1252-1873
N9020-60051
N9020-00013
5087-7326 or
N9030-60024
5022-7179
N9030-60010
N9020-60172
0515-0372
0515-1934
0515-1035
N9020-80138
N9020-80139
N9020-80148
N9020-80149
Installation Note N9030-90066