Keysight PXA N9030A Installation Note page 21

Signal analyzer frequency range upgrade from rf or microwave to millimeter wave frequency

Hide thumbs Also See for PXA N9030A:

Frequency Range Upgrade from RF or Microwave to Millimeter Wave Frequency

57.Refer to

Figure

10. Locate W51

port 1 and the other end to Attenuator B output. Torque to 10 inch-lbs.

Figure 10

W51 Cable Installation

58.Locate W8

N9020-20131

the Front End assembly A13A1J2. Refer also to

59.Locate W20

N9020-20152

assembly A13A1J4. Torque to 10 inch-lbs.

60.Locate W3

N9020-20072

assembly J701. Torque to 10 inch-lbs.

61.Reattach W33 cable 8121-1940 from the A16 Reference assembly J705 to the Front End

assembly A13A1J6. Torque to 10 inch-lbs.

Installation Note N9030-90066

N9020-20171

(1) in the kit and install one end to top switch

(2) in the kit and install between the A11 Low Band Switch J2 and

(3) in the kit and install between the YTO and the Front End

(4) in the kit and install from Attenuator A Cal In and A16 Reference

Figure

11. Torque to 10 inch-lbs.

Table of Contents