Table of Contents
Advertisement
Introduction
P
RODUCT
6
D
ESCRIPTION
The Linnox burner is a pre-mix type burner, especially
designed for direct-air heating applications where the lowest
achievable NOx and CO levels are required.
The Linnox burner combustion is based on high excess air pre-
mix combustion to keep the flame temperatures low. At the
same time the burner geometry establishes an internal
recirculating flame pattern. These two factors result in both very
low NOx and CO emissions at a high turn-down rate while
maintaining extremely stable combustion.
The Linnoxe burner is designed for applications where a linear
heat distribution is required.
A special feature is the possibility to configure the burner for
different capacities along the burner length by choosing from a
wide range of exchangeable burner modules of 300 mm length.
The Linnox burner is designed to provide:
•
Reliable operation
•
Simple adjustments
•
Direct spark ignition
•
Exchangeable igniter and flame rod from outside of the
installation.
•
Modulating control (Air and gas)
•
Exchangeable burner modules varying from 24 to 720 kW
per 300 mm.
Eclipse Linnox Model CCS-LS, Installation Guide 159, 2/20/04
1
Advertisement
Table of Contents
