ADJ STARSHIP User Instructions page 23

Starship
DMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: DMX Address,
DMX Channel Mode, and No DMX Status.
- DMX ADDRESS - In this submenu you can find and set your desired DMX address.
- DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.
- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the fixture
will go into when the DMX signal is lost. Listed below are the 3 modes.
• Hold Last - This setting will have the fixture stay in the last DMX setup.
• Auto - This setting will have the fixture go into auto mode.
• Sound - This setting will have the fixture go into sound active mode.
• Blackout - This setting will have the fixture go into stand by mode.
• Manual - This setting will have the fixture go into the current manual set up. See MANUAL CONTROL.
PERSONALITY - The submenus listed under PERSONALITY are as follows: Master, Slave, Status
Settings, Dim Modes, LED Refresh Rate, Gamma, Reset All Motors, Display, and Service.
- MASTER/SLAVE - In these two submenus you are able to set the unit as a "Master" or "Slave" in
a Master-Slave configuration. NOTE: The "Master" setting must also be activated in a Stand
Alone setup.
- STATUS SETTINGS - In this submenu you are able to access and adjust/change: Tilt Invert and
Tilt Speed.
- DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust the
dimming speed time.
- LED REFRESH RATE - In this submenu you are able to select your desired LED refresh rate.
- GAMMA - In this submenu you are able to select your desired gamma setting.
- RESET ALL MOTORS - In this submenu you are able to reset all motors.
- DISPLAY - In this submenu you you are able to adjust the display intensity, display invert, activate
the display blackout (Screen Saver Display), and activate/deactivate the display lock.
- SERVICE - In this submenu you are able to access: calibration adjustments (effect adjust) and
restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. See "MANUAL CONTROL"
in the system menu on page 19 for the various adjustments.
NOTE: NO DMX STATUS must be set to "Manual" when using Manual Control.
ADJ Products, LLC - www.adj.com - Starship User Manual Page 22
System Menu