Table of Contents
Advertisement
Starship
Installation
OVERHEAD RIGGING
The Starship is fully operational in three different mounting positions, hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m
(40ft) away from any flammable materials (decoration etc.). Always use and install the supplied safety
cable as a safety measure to prevent accidental damage and/or injury in the event the clamp fails
(see next page). Never use the carrying handles for secondary attachment. When installing the unit,
the trussing or area of installation must be able to hold 10 times the weight without any deformation. When
installing the unit must be secured with a secondary safety attachment, e.g. and appropriate safety
cable. Never stand directly below the unit when mounting, removing, or servicing the unit.
Overhead mounting requires extensive experience, including calculating working load limits, installation
material being used, and perodic safety inspection of all installation material and unit. If you lack
these qualifications, do not attempt the installation yourself.
These installaiton should be checked by a skilled person once a year.
CLAMP INSTALLATION
Screw one clamp via a M12 screw and nut into the Omega holder. Insert the quick-lock fasteners of
the Omega holder into the respective holes of the mounting plate. Tighten the quick-lock fasteners
fully clockwise. Pull the safety-cable through the two rigging points located on the bottom of the unit
and over the trussing system or a safe fixation spot. Insert the end in the carabine and tighten the
safety screw.
ADJ Products, LLC - www.adj.com - Starship User Manual Page 7
Advertisement
Table of Contents
