Assembly Instructions - FarmTek Growers Supply 112416S6X10 Instruction Manual

1
ASSEMBLE BENCH TOP SUPPORTS
Use the photos and information that follows to construct the bench top frame supports. The 12' bench has four (4) support assemblies. The 8' and
10' benches each have three (3) supports. Gather the parts required to complete one (1) support assembly:
• (2) S125P03175 square tube for legs
• (1) S125P057G14 square tube crossbar
• (4) 112391 four-bolt clamps
1. Gather the parts.
4. Set assembly flush with the end of the
square tube.
4 4

Assembly Instructions

• (8) FAG102B (1/4" x 3/4" hex bolts)
• (8) FALB10B (1/4" nuts)
• (12) FA4482B Tek screws
2. Construct two bracket assemblies. Do not
tighten the bolts at this time.
5. Slide the S125P057G14 crossbar square
tube into the bracket assembly.
3. Slide the assembly onto one S125P03175
square tube leg pipe.
IMPORTANT: Set tubes flush with the
ends of the bracket assembly.
Revision date: 08.26.15