Advertisement
4
INSTALL LONG BENCH TOP SUPPORT TUBES
1. Set one long 1.25" x 1.25" square tube on the
crossbars tight against the brackets.
NOTE: See diagrams in the Quick Start
section near the back of this guide for pipe
identification for your bench.
4. Take a 112431 angle clip and place it in
position against the crossbar and under the
support.
10
10
Assembly Instructions
•
•
Actual length may differ.
Measure and adjust as needed.
2. Verify that the pipe extends an equal length
beyond crossbar at each end of the frame.
ATTENTION: Actual dimension depends on
the length of the bench. Measure distances
and length and adjust as needed.
5. Use a piece of tape (not included) to hold the
clip in place. To prevent injury, do not hold
with fingers when installing the Tek screw.
(3) 1.25" x 1.25" square tubes (See Quick Start section for ID.)
112431 aluminum angle clips (Bench length determines quantity.)
3. Clamp the tube to the crossbar. Verify that tube
is tight against the crossbar brackets.
6. Take a Tek screw and secure the clip to the
crossbar. Remove the tape.
Revision date: 08.26.15
Advertisement
