Advertisement
5
ASSEMBLE BENCH TOP—continued
7. Move to the end rails and attach side rails as
shown. Position the channel edges of the side
rail on top of the upper and lower edges of the
end rail channel. See photo above.
10. Move to the side rail, brace one side, and
gently tap the side rail at each support tube to
seat the tubes to the side rails.
14
14
Assembly Instructions
8. With assistance, gently tap the rails to seat
the ends at the corner. Verify that the rails are
aligned as shown. Repeat at each corner.
11. Check the support tubes for square and verify
that each is aligned with the on-center marks
on each side rail. Do not install Tek screws at
this time.
9. Using a carpenter's square, square all corners.
Slide the entire frame assembly as needed to
square the frame.
NOTE: Sample frame is shown above. Size
and number of support tubes may differ
from your frame. See diagrams for your
frame near the back of this guide.
Revision date: 08.26.15
Advertisement
