Advertisement
5
ASSEMBLE BENCH TOP—continued
ATTENTION: Actual bench may differ from what is shown.
Consult the Quick Start Guide for your bench details.
12. With assistance, carefully lift the expanded
metal top and carry it to the assembled frame.
CAUTION: Metal is sharp! Wear gloves to
protect hands.
14. Measure diagonally and adjust frame as
needed until dimensions are similar. Expanded
metal top will sit tight to the tops of frame rails.
Revision date: 08.26.15
Assembly Instructions
13. Lower the expanded metal top into the frame.
Gently tap the frame rails as needed to allow
the top to drop into position. Do not force the
top into place or pound on the expaned metal.
15. Measure to find the center of each end rail and
mark the location.
102921B
FA4482B
Neo-Bonded
Tek Screw
Washer
NOTE: Use a block of wood or small hammer
if needed to lightly tap the frame rails apart to
allow the top to drop into place.
16. Take an FA4482B Tek screw and 102921B
neo-bonded washer and secure expanded
metal top to the end rail. Fastener should be
snug. Do not strip threads.
15
Advertisement
