Setup - NEC MultiSync PA311D User Manual

Connecting USB Devices
• It may take a few seconds for the monitor to recognize the USB input. Do not disconnect the USB cable or disconnect and
reconnect the USB cable before the monitor recognizes the input.
• Before turning off the main power switch of the monitor or shutting down Windows
remove the USB device from the monitor. Data may be lost or corrupted if the USB device is not disconnected properly.

Setup

For box contents, please refer to the printed contents sheet provided in the box.
The accessories included depends on the location where the monitor was shipped.
To connect the monitor to your system, follow these instructionsE:



OTEE: Make sure to read
1. Turn off the power to your computer.
2. Height adjustment is locked by a lock switch. Place a hand on top of the stand to push down to the lowest position. Slide the
lock switch to unlock the stand and raise the monitor screen (Figure B.1).
Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
(Figure B.2). Slide the cable cover up.



OTEE: Cable cover cannot be removed.
"Recommended Use" on page 4
Figure B.1
before installation.
Cable cover
English−16
, please turn off the USB function and
®
Maximum Tilt
Figure B.2