Setup - NEC MultiSync V554 User Manual

Setup

1. Determine the installation location
CAUTION
• Installing your LCD monitor must be done by a qualified
technician. Contact your supplier for more information.
• MOVING OR INSTALLING THE LCD MONITOR MUST
BE DONE BY TWO OR MORE PEOPLE. Failure to follow
this caution may result in injury if the LCD monitor falls.
• Do not mount or operate the monitor upside down.
NOTE: This LCD monitor has internal temperature
sensors and cooling fans, including a fan for the
option board.
If the LCD monitor becomes too hot, the cooling
fans will turn on automatically.
The option board's fan is active although the
temperature is lower than normal operating
temperature for cooling the option board. If the
LCD monitor becomes overheated while the
cooling fan is running, a "Caution" warning will
appear. If the "Caution" warning appears, stop
using the unit and allow it to cool. Using the
cooling fans will reduce the likelihood of early unit
failure and may help reduce image degradation
and "Image Persistance".
CAUTION: If the LCD monitor is used in an enclosed
area or if the LCD panel is covered with
a protective screen, please check the
inside temperature of the monitor by using
the "HEAT STATUS" control in the OSD
(see page 40). If the temperature is higher
than the normal operating temperature,
please turn the cooling fan to ON within
the FAN CONTROL menu within the OSD
(see page 40).
IMPORTANT: To avoid scratching the LCD panel, always
place a soft cloth, such as a blanket that is
larger than the monitor's screen area, on the
table before laying the monitor face down.
2. Install the remote control batteries
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
A. Press and slide to open the cover.
B. Align the batteries according to the (+) and (–) indications
inside the case.
C. Replace the cover.
CAUTION: Incorrect usage of batteries can result in
leaks or bursting.
NEC recommends the following battery use:
•
•
•
•
•
NOTE:
3. Connect external equipment
(See page 16, page 17 and page 18)
•
•
NOTE:
4. Connect the supplied power cord
•
•
ature is higher
•
NOTE:
English-14
Place "AAA" size batteries matching the (+) and (-) signs
on each battery to the (+) and (-) signs of the battery
compartment.
Do not mix battery brands.
Do not combine new and old batteries. This can shorten
battery life or cause liquid leakage of batteries.
Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
Do not touch exposed battery acid, it may injure your skin.
If you do not intend to use the Remote Control for
a long period of time, remove the batteries.
To protect the external equipment, turn off the main power
before making connections.
Refer to the user's manual of your equipment for further
information.
Do not connect/disconnect cables when turning
on the monitor or other external equipment, as this
may result in a loss of the monitor image.
The equipment should be installed close to an easily
accessible power outlet.
Fasten the power cord to the LCD monitor by attaching
the screw and clamp. (Recommended Fasten Force:
139 - 189N•cm).
Fully insert the prongs into the power outlet socket.
A loose connection may cause image degradation.
Please refer to the "Important Information"
section of this user's manual for proper
selection of an AC power cord.
Screw
Clamp