Set The Ip Address Of The Computer - 3onedata GW11 Series User Manual

1.2 Set the IP address of the Computer

The default management of the Modbus Gataway device is as follows:
IP Settings
IP address
Subnet mask
When configuring a Gataway through the Web:
Before making remote configuration, make sure that the route between the

computer and the Gataway is reachable.
Before making a local configuration, make sure that the IP address of the

computer and the Gataway are on the same subnet.
Note:
When the switch is first configured, if it is configured locally, make sure the current
computer network segment is 1.
IP configuration example
For example, suppose that the IP address of the computer is 192.168.5.60, need to
change the IP address of the network segment "5" to "1"
Operation steps
The steps are as follows:
Step 1 Open "Control panel > Network connection > Local area connection > Properties >
Internet protocol version (TCP/IPv4) Properties".
Step 2 Change the "5" selected by the red frame in the figure to "1".
Default Values
192.168.1.254
255.255.255.0
3onedata proprietary and confidential
Copyright © Shenzhen 3onedata Technology Co., Ltd.
(I)GW11XX Modbus User Manual
2