Setting Up; Adjusting Drawbar - DAL-BO MaxiCut 200 Instruction Manual

MaxiCut is very simple to work with. The design makes it very simple to set
up, although the main frame must be horizontal.
Always check frame angle before use to ensure optimum use of the machine.

Adjusting drawbar

To ensure uniform cutting, the drums must be horizontal on the drawbar. The
side frames can swing in relation to the lie of the field.
Incorrect drawbar height can cause uneven compression of the soil, as the
roller will not apply equal pressure for all sections. If the drawbar is low at
the back, the tractor lift arm is too high. If the drawbar is low at the front,
raise the tractor lift arm.

Setting up

MaxiCut 600 at work. The main
frame is horizontal whilst the side
frames are free to swing.
MaxiCut
Fig. 3
HORIZONTAL
Side 15