Removal/Fitting Wheel; Replacing Wheel Bearings - DAL-BO MaxiCut 200 Instruction Manual

Removal/fitting wheel

Raise wheel frame before removing wheel. Wheels will then be raised free of
ground. Remove wheel nuts. Remove wheel. Replace wheel, hand-tighten
wheel nuts. Lower wheels to ground. Tighten wheel nuts to 300 Nm.
Ensure wheel nuts and wheel surfaces are clean to avoid nuts loosening.

Replacing wheel bearings

1. Remove hub cap pos. 21.
2. Remove split pin pos. 20.
3. Remove castle nut pos. 19.
4. Hub housing can now be re-
5. Remove bearings pos. 17+18.
6. Remove seal ring pos. 19.
Assembly
moved from shaft.
1. Fit bearing outer rings pos. 17+18 in hub housing pos. 22
2. Fit seal ring pos. 16.
3. Fit bearing inner ring pos. 18 on axle pos. 2 and fit axle in hub hous-
ing
4. Fit bearing inner ring pos. 17 on axle pos. 2
5. Screw castle nut onto axle pos. 2, whilst turning hub housing pos. 22.
Tighten castle nut until hub housing revolves slowly. Slacken castle
nut a quarter turn or until hub housing revolves easily.
6. Fit split pin pos. 20.
7. Fill hub cap pos. 21 half full with ball bearing grease and fit to hub
MaxiCut
Fig. 12
Side 25