Replacing Gasket Set For Extend/Retract Cylinder - DAL-BO MaxiCut 200 Instruction Manual

Activate cylinders after assembly. Activate cylinders both ways, retract-
ing/extending fully in both outer positions. This is necessary to bleed the sy-
stem and cylinder.
Ensure no personnel are within the extension radius of the side sections.

Replacing gasket set for extend/retract cylinder

Fig. 9
1. For cylinder removal, see "Replacing extend cylinder for retracting side
2. Drain oil from cylinder by moving ram carefully backwards and forwards.
3. Extend ram to centre position. Unscrew upper part (pos. 3) from cylinder
4. Remove lock nut retaining collar shoe (pos. 4).
5. Remove collar shoe (pos. 4) from ram.
6. Remove upper part (pos. 3) from ram.
7. Remove gaskets in upper part and collar shoe, (pos. 5+6+7+8+9).
8. Clean all parts and check for particles etc. Check for rust around scraper
Side 22
sections".
tube (pos. 1). Use special tool to remove upper part. If upper part is stuck,
heat front of sleeve. When upper part is detached from cylinder tube, pull
ram up towards upper part and remove completely from cylinder tube.
ring (pos. 5) in upper part. If detected, remove thoroughly.
MaxiCut