Coupling And Uncoupling; Coupling; The Angle Of The Lift Arms; Hydraulics - DAL-BO Levelflex 2000 Manual

The front hanger is manufactured in accordance with the DS/ISO 730-1 cate-
gory II. If your tractor is not suitable for this type, please contact your distrib-
utor. The arms of the front lift must be able to move sideways.

Coupling

First install the arms of the lift with the lift taps and hereafter install the top
link. The top link must be adjusted so the frame head is in a horizontal posi-
tion and thus, parallel with the base. Raise the implement, so the support legs
are clear of the ground and then place it in an operating position.

The angle of the lift arms

With the machine placed in a position of operation, aim at placing the trac-
tor's lift arms in an angle preferably a couple of degrees above horizontal or
at least horizontal. In this way, the machine will more easily roll over any ob-
stacles as the tractor presses the implement tilted upwards and the steering
will simultaneously be maintained. (Steering can additionally be made easier
if the top link is a bit shortened, so the frame head points a few degrees up-
wards at front).
Plate 1

Hydraulics

Depending on the type of Levelflex 2000 there are different requirements for
hydraulic tapping on the tractor.
Levelflex 2000
Solid frame
Solid frame w. crackeboard
Hyd. frame
Hyd. frame w. cracker-
board
The hydraulic tubes are attached to a 1/2" female coupling, which is joined
with the front lift.
∇
Remember to secure the lift arms and the top link joints with cotter pins.
Levelflex 2000

Coupling and uncoupling

A
Number of double-acting hydraulic tappings
none
1
1
2
side 5