Mounting; Replacing Raise/Lower Cylinder - DAL-BO MaxiCut 200 Instruction Manual

Mounting

1. Fit new gaskets (pos. 2+4+7+8+9) in upper part and collar shoe. Remem-
ber to check gaskets are facing the right way.
2. Lubricate thread in upper part (pos. 3) with oil.
3. Fit upper part (pos. 3) on ram shaft.
4. Fit collar shoe (pos. 4) and screw on lock nut, secure with Loctite. En-
sure that thread is absolutely clean and free of oil or other impurities be-
fore applying Loctite. Do not fill with oil for 12 hours after use of Loc-
tite.
5. Lubricate outer collar shoe gasket in contact with cylinder tube and inside
of cylinder tube with oil, push ram into centre position.
6. Fit upper part onto cylinder tube and tighten.
7. Fit cylinder (see "Replacing extend cylinder for retracting side sections").

Replacing raise/lower cylinder

Extend roller and relieve pressure
on raise/lower cylinder (A).
1. Disconnect hoses from cylinder
2. Support cylinder
3. Remove split pins in pins, remove pins
4. Remove cylinder
5. Fit new or repaired cylinder
Activate cylinders after assembly. Activate cylinders both ways, retract-
ing/extending fully in both outer positions. This is necessary to bleed the sy-
stem and cylinder.
Ensure no personnel are within the extension radius of the side sections.
MaxiCut
Fig. 10
A
Side 23