Replacing Blades; Fitting Blades - DAL-BO MaxiCut 200 Instruction Manual

Replacing blades

If no crane is available, remove both side section axles to prevent roller tip-
ping over.
1. Extend machine to working po-
sition.
2. Remove any soil (A) between
blades.
3. Remove protective plate be-
tween blades to reach blade
bolts.
4. Blades can now be unbolted and
removed.

Fitting blades

1. Fit blades with new carriage bolts, see diagram below for direction. Arrow
points in direction of travel.
2. Fit protective plates between blades last.
Fig. 15
Ensure no personnel are within the machine's extension radius when activat-
ing hydraulics.
MaxiCut
Fig. 14
A
Side 27