Uses - DAL-BO MaxiCut 200 Instruction Manual

MaxiCut is a newly-developed heavy blade roller, designed for use on crops
with long, thick stems. By cutting the remaining organic materials, decompo-
sition is accelerated.
MaxiCut is used after harvesting on crops such as maize, sunflower or rape,
when the total weight of the machine and ground conditions are optimum.
When the rollers are filled with water and the ground is as dry as possible, the
machine is at its most effective.
The machine has to be operated at relatively high speeds of over 15 km per
hour, preferably 18-25 km per hour at which the rollers will perform best on
stubble and plant residue. For an extra thorough result, another run can be
made over the field.
The rollers are designed to be filled with water if required. The machine
comes from the factory without water to simplify transport.
The steel tubes may only be filled with water or liquid with a density less
than 1.15 g / cm³. This avoids overloading the machine's hydraulics and
welded frames.
Side 12
MaxiCut is a blade roller, on which
the sections are independent of each
other. Heavy-duty bearings are stan-
dard.
MaxiCut

Uses

Fig. 1
MaxiCut 600 at work