Troubleshooting - DAL-BO MaxiCut 200 Instruction Manual

Fault
Mid-section apply-
ing too much pres-
sure
Side sections
pressing too much
Blades not cutting
sufficiently
Side 18
MaxiCut

Troubleshooting

Cause
• Drawbar
high
• Too much water
• Too much water
• Drawbar too low
• Wheel
frame
touching ground
• Blades worn
• Drum not heavy
enough.
• Field/surface too
soft
Remedy
• Adjust drawbar to horizontal
too
(see "Adjusting drawbar")
• Adjust volume of water to the
same in all three rollers
• Adjust volume of water to the
same in all three rollers
• Adjust drawbar and mid-section
(see "Adjusting drawbar")
• Lift wheel frame higher
• Replace with new blades
• Fill rollers with water
• Wait until field is dry