Standard Features - Eaglemaster E2 Instruction Manual

STANDARD FEATURES:

-
To ARM the system:
To arm your system within proper operation range, simply press button
in disarmed or Acc off position) . The system will respond one siren chirp, one lights flash,
doors lock, disable engine starter, LED will begin flashing quickly until all sensor inputs are active
- LED will start blinking slowly (flash once per second) to indicate the system is full armed.
Main unit sends signal to 2-way remote to confirm Arm and
give one beep sound.
DEFECTIVE ZONE BYPASS:
If the security system is armed at the same time that an input is active (such as a door opening
or hood / trunk opening ), you will hear one siren chirp to indicate arming and after 8 seconds
a second siren chirp to indicate Bypass Notification. A Bypass Notification chirp means that the
security system ignores the input that was active when the system was armed, until that input
ceases.
Defective zone
Door not closing
Hood / Trunk not closing
AUTO RESET:
If a violation occurs the system will respond by sounding the siren and flashing the lights for
approximately 30sec. before the system resets itself and continues to protect your car. If violation
still occurs the system, siren and lights will working for 8 cycles then the system reset itself and
continues to protect other zones.
- Arm without siren chirp :
To arm your system without siren chirp , simply press button
button once.
Note: this features is only activated under the system is in disarmed and Acc off position,.
- To DISARM the system :
To disarm your system within proper operating range, simply press button
system in arm position). The system will respond two siren chirp, two light flash, doors unlock,
Enable your engine starter, LED off. Main unit sends the signal to 2-way remote to confirm
Disarm and indicator will flash twice and give two beep sound.
INTRUSION ALERT:
Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates
4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following
different triggering.
2-Way remote intrusion alert
Siren chirps
3 chirps
4 chirps
Quick flash 2 times after a pause
Quick flash 3 times after a pause
Quick flash 4 times after a pause
Quick flash 5 times after a pause
Quick flash 6 times after a pause
Flashing 2sec.
Flashing 2sec.
Flashing 2sec.
Flashing 2sec.
indicator will flash once and
2-way beeps
3 beeps
4 beeps
once then within 3sec. press
Sensor 1st-stage triggered
Sensor 2nd-stage triggered
Door switch triggered
Hood/Trunk switch triggered
Ignition switch triggered.
Shock Sensor triggered
Door switch triggered
Hood/Trunk switch triggered
Ignition switch triggered.
-5-
once (while system
2-way LED indicator
once (while