Eaglemaster E2 Instruction Manual page 8

- Remote sensor by pass :
This system offer 2stage sensor optional. Within 8sec. after set arming, to press button
once , the system will give 2 short chirps and 2 lights flash, thus the 1st stage shock
sensor has been turn off.
Press button once again, within 8sec. the system will give 3 short chirps and 3 lights
flash, thus the 2nd stage shock sensor has been turn off.
If press button
turn ON again.
Note: - if remote sensor bypassed, it will be detected again by next arming.
- if armed with silent mode, to operate sensor bypass will only indicate by
lights flash.
- Valet mode:
If you are going to have your vehicle serviced, parked by a valet or washed you will want
to put your security system Into valet mode. To enter valet mode disarm the system and
turn Ignition switch to ON position , then press button
siren give 1 long with 1 short chirp and LED light ON to confirm the system is in valet
mode. When the system is in the valet mode it can not be armed. The door lock and
unlock will function as keyless entry system. The 2-Way remote will respond 1 long and
1 short beeps.
To EXIT: Turn Ignition switch to ON position , then press button
2seconds, you will hear siren provide 1 long with 2 short chirps and LED light OFF to
confirm exit this mode and in alarm mode. The 2-Way remote will respond 1 long and
2 short beeps.
Note: While in the Valet mode, each time when Ignition switch has been turn off, the
siren will provide 2 chirps for warning sound.
- Ignition safety door lock select (programmable):
If programmed with this feature, turn Ignition ON after 10 seconds the doors will auto
locked , but within this 10 seconds the door has been opened this feature will bypassed,
till next time of ignition on. When turn Ignition OFF, the doors will unlock for take off.
Note: You may manage lock and unlock doors in ignition on position by short pressing
button to lock door or pressing
- Passive immobilizer (programmable):
If programmed with this function, when turn off ignition switch for 30 seconds or you
open and close the door, it will disable the engine starter right way . The LED will flash
twice per second.
The 2-Way remote will respond
Exit: To disarm this function by (1) simply press button
or (2) Turn Ignition on then press Valet /over-ride switch once, LED off.
Note: The 2-Way will give one beep sound and one
immobilizer activated.
- Emergency reset switch:
If the remote has been lost or damage, or forgot the PIN code number the owner can
enter the car by using the key. It will act the alarm. To disarm the alarm turn ignition on
and press reset switch once , it will disarm the alarm immediately. (Please ask your
installer this reset switch location).
Note: after this emergency reset activated, the PIN code will resumed factory setting
PIN code "6"
once (at 3 times) again within 8sec. of arming the shock sensor will
indicator flashing twice per second.
+
to unlock door.
once. LED off.
indicator flash when this
-7-
for over 2 seconds until
+ for over