Eaglemaster E2 Instruction Manual page 9

- Channel-2 (-) output(programmable):
This channel "Orange/black wire" is a negative (-500mA) output features, this feature
can be controlled " Disarmed output / Turbo mode (engine running) / Dome light " ,
2nd killer:
If programmed with the feature , the channel will constant output when the system
disarmed, this feature normally for 2nd immobilizer. 40A relay is required, COM & NO.
Turbo mode(engine running):
If programmed with the Turbo mode, this feature for the car with turbo time keeps engine
running 3 minutes after arriving at your destination.
To operate this turbo mode by pressing
siren will give one chirp and the LED will start flashing fast, at the time the system is in
standby turbo time mode, the owner must follow under process to activate the Turbo
mode:
(1) Within 15sec. Turn Acc off (engine still keep running), open and close door to leave
the car.
Note: If within this 15sec. press any button once will exit the mode, LED off.
(2) While leaving the car by open and close the door, within 5sec. press button
the system will arm immediately, the parking lights will keep flashing, however the
engine will still keep running for 3 minutes and then in armed. The 2-Way remote will
respond
indicator flash once and give 1 beep.
Note:(1) After leaving the car, within 5sec. press wrong button will exit the mode.
(2) After leaving the car, within 5sec. without press
automatically.
Exit turbo mode :
Pressing button
NOTE:
1. In Turbo mode, the sensor zone trigger will be bypassed until the turbo time finished.
2. In Turbo mode, if door, hood or trunk has been triggered, engine will stop running and
alarming the system, and to disarm the system must use your PIN code.
Dome Light:
If programmed with the feature , the channel will output 30sec. when disarming .
-Channel-3 (-) output (programmable):
This channel "Gray wire" is a negative (-500mA) output features, this feature can be
controlled " Trunk open / Turbo mode / 2nd stage unlcok" .
Trunk open :
if programmed with Trunk open feature, simply press and hold button
the channel will output for 1 second pulse , this feature normally for open the trunk.
Note:
1. if trunk has been remote opened in arming position, hood/trunk switch will delay
sensing for 20 seconds, and the shock sensor will be bypassed.
2. If remote trunk in armed position, the 2-Way remote will respond
flashing every 2sec. If trunk keep opened for over 1minutes, it will give 8 beeps .
Turbo mode:
Same instructions / operation as Channel-2 turbo time mode.
2nd stage unlock:
If programmed with the feature , t
unlock will be output for passenger side .
indicator flashing fast every 2sec. until system armed by
once within turbo time , the system will exit turbo mode and in armed.
o operate it by press button
for 2sec. while driving or ignition ON , the
-8-
button will exit mode
over 2 seconds,
indicator
at 2nd time , 2nd stage
once,