Alarm Page; Remote Button 1.2.3 On/Off - Eaglemaster E2 Instruction Manual

Alarm Page

If the alarm system is triggered while armed, an Alarm Page will be sent to the remote
control. When the remote receives an Alarm Page, the LED icons will display the alarm
system status information and the remote control will generate beeps.
Display
1-flash
flash within 20sec.
flash within 20sec.
flash within 20sec.
flash within 20sec.
NOTE: Vibrations features may apply to the model No: "E2-LED-VB".
Page Recognition (Acknowledgement)
To clear a page alert/notification, quickly press any button on the remote control. This
can be performed at any time during or after the page notification has occurred.
The remote control will not send a command to the system at this time; it will only clear
future repeats of the page notification. The next time a button is pressed on the remote
control it will send a command to the system.
Check in-range notification (programmable)
If programmed with the feature, after arming the system, main unit system will send 5-
signals to 2-Way remote within 6~7 minutes. If the 2-Way remote is out-range, the
remote responds with 2 long beeps and
Programming 2-way remote
Disable remote receiving
You may turn off the 2-Way remote receiving signal from the main unit. Press button
simultaneously for 2sec. until one long beep is heard. Remote receiving is now
disabled. To turn on receiving again, Press button
beep is heard, remote receiving is now enable.

Remote button 1.2.3 on/off

For safety purpose, this 2-way remote can be lockout the remote button in order not to
mis-touched the buttons. Press button
button is now locked. To turn on remote button, press button
beeps is heard, remote button is now unlocked.
Vibrate mode on/off
Press button for over 2sec. the 2-way remote will respond tone & vibrate feature,
the button pressing 2sec. will change the feature, see under table:
Beeps
1-beep
1-beep
Beeps Vibrations
1 times
5 short
2 times periodically
Melody 1
3 times periodically
Melody 2
4 times periodically
Melody 3
5 times periodically
Melody 4
for over 2sec. until one beep is heard, remote
(this feature may apply to the model "E2-LED-VB")
Vibrations
2-way remote feature
1-time
Remote with tone and vibration
1-time Remote with vibration only
Remote with tone only
-4-
Trigger
Sensor warning
Shock sensor triggering
Door switch triggering
Hood / Trunk triggering
Ignition triggering
indicator flashing slowly .
simultaneously until two long
for over 2sec. unitl two