Eaglemaster E2 Instruction Manual page 12

Transmitter & PIN code programming:
This programming features is provide the owner to learn the new transmitter or set new PIN
code into the system memory. This system can expand 4 different transmitters, and comes from
factory with two transmitters already programmed into the system memory. The PIN code from
1 ~30 numbers is available to set into the system memory.
Whenever you want to add or delete transmitter code ; or set your own PIN code of the system,
the produces are as following:
1.
In Disarmed position, turning ignition switch from ON-OFF for 8 times within 10 seconds
and stay in the OFF position, siren will provide 1-long chirp to indicate that the system is in
this programming mode.
2.
During step 1. Ignition switch stay in the OFF position:
It's available to learn the new transmitter into the system by press any button once of the new
transmitter, siren will give 1-long and 1-short chirps to indicate the first transmitter code learn
into the system memory. T o learn the 2nd,3rd,4th new transmitters, simply press any button
once on the each transmitter, the numbers of siren short chirps is according to the numbers of
the new transmitters learn into the system memory . (Each time learning new code of remote,
the old code will be erased, hence you have to learn again.)
Note: If learning 2-Way remote, the 2-Way remote will respond 1 beep follow with melody sound
to indicate the code has been learned.
Exit: To exit this programming mode, if there is no new transmitters button been pressed, and
ignition not turn ON, after 8sec. siren will give 2-long and 2-short chirps to indicate that the
system has been exit the programming mode.
3.
During step 1 or step 2. Turning ignition switch to the ON position:
It's available to set the new PIN code into the system, siren will give 1-long and 1-short chirps
to indicate that the system is in PIN code setting mode, at the time LED will start flashing, the
times of LED flashing is according to the numbers of the PIN code, let's say you want to set
the PIN code " 12", while LED flashing 12 times then turning ignition switch to the OFF
position, thus the new PIN code "12" has been programmed, the siren will give 2-long and
2-short chirps and then LED will auto flashing 12 times as showing the new PIN code for the
owner of final notification.
Note: During the LED flashing of the counting numbers, if ignition switch not been turn off, the
LED will keep flashing 30times and the system will auto exit this mode, siren will give
2-long and 2-short chirps, thus the PIN code "30" has been programmed.
Note: During the LED flashing of final notification, alarm will not allow to activated.
-11-