Power Disconnecting Memory; Vehicle Status Checking - Eaglemaster E2 Instruction Manual

-Channel-4 (-) output(programmable):
This channel "Pink wire" is a negative (-500mA) output features, this feature can be
controlled " Window output / Turbo mode / Horn".
Window close :
If programmed with the Window output feature, this channel will constant outputting for
30 seconds when system armed for window close feature.
Note: the sensor will be bypassed when window is output.
Turbo mode:
Same instructions / operation as Channel-2 turbo time mode.
Horn pulse:
If programmed with Horn pulse output, for additional vehicle's horn honk output alert.
- 2 step disarm:
This system offers 2 step disarm. It's a feature that make it possible to silence and reset
the system while it is triggering, without disarming the system. If the system is triggered
and the siren has been sounding, pressing any button once on the remote transmitter
will stop the trigger and return the unit to the armed state.

- Power disconnecting memory :

Alarm is built in memory on main unit. Generally, after alarm power is cut off and
reconnect, main unit will read back these data make the alarm to resume. When in
disarm, arm or valet mode position, power off then on , alarm will read back original
position.

- Vehicle status checking:

The 2-Way remote offer the feature to check the current status of the car, simply press
button once within proper operation range. The main unit will send the signals to
the 2-Way remote about the vehicle current status. Please see under table.
Display
1-flash
2-flash
1-flash
2-flash
- How to use your PIN code:
If the remote control has been lost or damaged, you can manually disarm your system by
enter your own PIN code .(The system's factory-set PIN code is "6" )
Turning the Ignition switch from OFF to ON position, LED will start flashing, the times of
LED flashing is according to the PIN code numbers, while LED flash 6 times then turning
the ignition switch to the OFF position , the system will disarmed immediately and siren
will give 4-short chirps.
NOTE:
Each cycle of alarm triggering is only provide one time to set PIN code, otherwise the
owner must wait next cycle triggering and then set PIN code again to disarm the system.
If the owner forgot the PIN code number, must use "Emergency reset switch " to reset the
alarm system (please see "Emergency reset switch" ), after this emergency reset switch
has been activated, the system PIN code will resume back to the original factory PIN
code "6" .
Beeps
1-short
2-short
1-long + 1-short
1-long + 1-short
Vehicle current status
Vehicle in armed position
Vehicle in disarmed position
Vehicle in Valet mode /door loc ked
Vehicle in Valet mode/do or unlocked
-9-