Vehicle Status Checking; Power Disconnecting Memory - Eaglemaster E1 Plus Instruction Manual

- Ignition safety door lock select (programmable):
If programmed with this feature, turn Ignition ON after 10 seconds the doors will auto
locked , but within this 10 seconds the door has been opened this feature will bypassed,
till next time of ignition on. When turn Ignition OFF, the doors will unlock for take off.
Note: You may manage lock and unlock doors in ignition on position by short pressing
button to lock door or pressing
- Passive immobilizer (programmable):
If programmed with this function, when turn off ignition switch for 30 seconds or you open
and close the door, it will disable the engine starter right way . The LED will flash twice
per second.
2-way LCD display :
Exit: To disarm this function by (1) simply press button
or (2) Turn Ignition on then press the call switch once, LED off.
Enter Arm: Under this mode, you may enter full Arm mode, simply press button
will arm the system immediately.
- Emergency reset switch: (for installer only)
If the remote has been lost or damage, or forgot the PIN code number the owner can
enter the car by using the key. It will act the alarm. To disarm the alarm turn ignition on
and press reset switch once , it will disarm the alarm immediately. (Please ask your
installer this reset switch location).
Note: after this emergency reset activated, the PIN code will resumed factory setting
PIN code "6"

- Vehicle status checking:

The 2-Way remote offer the feature to check the current status of the car, simply press
button once within proper operation range. The main unit will send the signals to
the 2-Way remote about the vehicle current status.
Note: If the 2-way remote out of range., Then LCD will without any display icons and
give 2 beep sound with 2 vibrations for identify out of range.
- 2-way back light :
The 2-Way remote offer the feature to light on the LCD display , simply press button
, the back light will on for 3 seconds and also display the vehicle status.
- 2 step disarm:
This system offers 2 step disarm. It's a feature that make it possible to silence and reset
the system while it is triggering, without disarming the system. If the system is triggered
and the siren has been sounding, pressing any button once on the remote transmitter will
stop remote pager triggering, the next time if
triggering and bypass that zone.

- Power disconnecting memory :

Alarm is built in memory on main unit. Generally, after alarm power is cut off and reconnect,
main unit will read back these data make the alarm to resume. When in disarm, or valet
mode position, power off then on , alarm will read back original position. The system will be
alarming if power off then on in the Armed position.
to unlock door.
+ One beep sound
once. LED off.
button is pressed it will stop the unit
-10-
once,
once