Configuring Snmp Support On Linux; Configuring Snmp Support On Netware - Adaptec Storage Manager User Manual

Configuring SNMP Support on Linux

For the Linux operating system, the Adaptec Storage Manager SNMP
agent is a sub-agent that interfaces with the UCD-SNMP agentx
architecture. UCD-SNMP is a third-party package for Linux; for
information, documentation, and downloads, see
To configure SNMP support:
Install Adaptec Storage Manager (see
1
Configure the UCD-SNMP master agent to be used with agentx.
2
Start the Adaptec Storage Manager SNMP sub-agent:
3
From the Adaptec Storage Manager installation directory, run the
executable.
aus-snmpd
Refer to your Linux documentation for information on configuring
UCD-SNMP, agentx, and setting up traps.

Configuring SNMP Support on NetWare

To install Adaptec Storage Manager SNMP support, at the command
prompt type this command, then press Enter:
load AUS-SNMP.NLM
Refer to your NetWare documentation for information on configuring
traps.
Appendix A: Configuring SNMP Support
www.net-snmp.org
page 28).
155
.