Wiring The Control Circuit - YASKAWA VS-606V7 Series Instruction Manual

Wiring the Control Circuit

Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
• Control Circuit terminals
Pass the cable through wiring hole and connect. Be sure to mount the covers
on the original position.
MA MB MC
* SW1 can be changed according to sequence input
signal (S1 to S7) polarity.
0V common: NPN side (Initial setting)
+24V common: PNP side
Refer to pages 154 and 155 for SW1.
Refer to pages 80 and 90 for SW2.
Wiring the control circuit terminals
Insert the wire into the lower part of the terminal block and connect it
tightly with a screwdriver.
5.5 mm
(0.22 in.)
MA MB MC CONTACT OUTPUT
S5 S6 S7 P1 P2
S1 S2 S3 S4 SC PC S S AM AC RP
SW1
PNP
NPN
13 14
12
2 3
1
Wire sheath strip length must be 5.5mm (0.22in.).
R R FS FR FC
SW2
OFF ON
1
V I
2
22
11
Screwdriver blade width
0.4 mm max
(0.016 in.)
2.5 mm max
(0.098 in.)
29