YASKAWA VS MINI J7 Series Instruction Manual page 31

All manuals and user guides at all-guides.com
Register
No. for
No. Name
Trans-
mission
Stall prevention (current
57 0139H
limit) during running
Frequency detection
58 013AH
level
59 013BH Overtorque detection
Overtorque detection
60 013CH
level
Overtorque detection
61 013DH
time
Memory selection of hold
62 013EH
output frequency
Torque compensation
63 013FH
gain
64 0140H Motor rated slip
65 0141H Motor no-load current
66 0142H Slip compensation gain
Slip compensation
67 0143H
primary delay time
Timeover detection
68 0144H
selection
Setting unit selection of
communications
69 0145H
frequency reference/
frequency monitor
Setting unit: 1%
Setting range: 30 ~ 200%
(Note): If set at 200%, this function will
not operate.
Setting unit: 0.1Hz (less than 100Hz) /
1Hz (100Hz or greater)
Setting range: 0.00 ~ 400Hz
0: Overtorque detection disabled.
1: Detects only at speed agree, opera-
tion continues after detection.
2: Detects only at speed agree, output
is shut down after detection.
3: Detects during run, operation contin-
ued after detection.
4: Detects during run, output is shut
down after detection.
Setting unit: 1%
Setting range: 30 ~ 200%
Setting unit: 0.1s
Setting range: 0.1 ~ 10.0s
0: Hold output frequency is not stored.
1: Hold output frequency is stored.
Setting unit: 0.1
Setting range: 0.0 ~ 2.5
Setting unit: 0.1Hz
Setting range: 0.0 ~ 20.0Hz
Setting unit: 1%
Setting range: 0 ~ 99%
Setting unit: 0.1
Setting range: 0.0 ~ 2.5
Setting unit: 0.1s
Setting range: 0.0 ~ 25.5s
0: Timeover detection enabled. (Coast
to stop)
1: Timeover detection enabled.
(Deceleration stop by deceleration
time 1)
2: Timeover detection enabled.
(Deceleration stop by deceleration
time 2)
3: Timeover detection enabled.
(Operation continues, alarm displays)
4: Timeover detection disabled.
0: 0.1Hz / 1
1: 0.01Hz / 1
2: 100% / 30000
3: 0.1% / 1
Initial User Ref.
Setting Setting Page
160% 92
0.0Hz 74
0 73
160% 73
0.1s 73
0 86
1.0 60
(Note 2) -
(Note 2) -
1.0 93
2.0s 93
0 -
0 -
31