(6.3) Interface; (6.3.1) Bms; 1) Bms Address; (6.4) Display - Bender ISOMETER iso1685DP Manual

Settings
9.1

(6.3) Interface

Set the parameters for connection of other devices to the ISOMETER® in the interface
menu:
9.1

(6.3.1) BMS

Set the parameters for communication with other devices via the BMS bus.
9.1

(6.3.1.1) BMS address

Select an address between 1 and 90 for the BMS bus.
9.1

(6.4) Display

Adjust the display brightness for the ISOMETER® in the display menu:
9.1

(6.4.1) Brightness

Adjust the display brightness between 0 % and 100 % in steps of 10.
If no button is pressed on the display for 15 minutes, the brightness of the display will be
reduced. If now a button is pressed, the normal brightness is restored.
9.1

(6.5) Password

Use the password function to protect the device parameters against unauthorised adjust-
ment. The default password is 0000.
9.1

(6.5.1) Password

Enter an individual four-digit password.
9.1

(6.5.2) Status

Decide whether the password query should be used:
•on
•off
39
Password query active
Password query inactive
Settings
9.1

(6.6) Commissioning

In the commissioning menu, you can open the ISOMETER®'s commissioning wizard again.
9.1

(6.7) Service

The service menu can only be accessed by Bender service staff.
9.1 7.0 Info
The ISOMETER®'s current settings can be viewed in the Info menu. Navigate through the
different views using the and buttons:
•Info - Device
•Info - Software
•Info - Measurement
technique
•Info - Clock
•Info - BMS
Device name, serial number, article number
Software version measurement technique,
software version HMI
Set profile, locating current and EDS mode
Time, date, summer time
Address of the RS-485 interface
iso1685DP_D00272_02_M_XXEN/07.2017