Adaptec ANA-62000 User Manual page 88

DuraLAN Fast Ethernet NICs User's Guide
3
In the Available Adaptec Ports box, click the available port to
add to the group, and then click Add.
4
Repeat step 3 for each additional port.
Note:
You must assign the same connection type to
each port in the same group.
O . To remove a port from the group, click the
PTIONAL
appropriate port from the Group Ports box, and then click
Remove.
5
When you are finished configuring the group, click Apply.
6
To create another group, repeat steps 1 through 5.
7
If you want to rename a group:
a
Select the default group name in the Group(s) list box.
b
Type the new name.
c
Click Apply.
8
When you are finished configuring all groups, click OK.
9
If SNMP is not set up on the computer, you will receive the
message below. Click OK.
This message may be ignored during this
Figure 8-4.
8-6
installation.