Adaptec ANA-62000 User Manual page 81

7
When you are done, click OK. you will return to the Network
Settings Window.
Figure 7-6. Network Setting Window
8
Click OK.
Note:
The Adapters tab identifies one model only, even
when several DuraLAN NIC models are installed. The
DuraLAN NIC model displayed is the same as the first
model you chose in step 8 during the driver installation.
9
If SNMP is not set up, you will receive the Setup Message below.
Click OK.
Figure 7-7. This message may be ignored during this installation.
Duralink64 Failover for Windows NT
7-7