Adaptec ANA-62000 User Manual page 79

8
If SNMP is not set up, you will receive the Setup Message below.
Click OK.
Figure 7-4. This message may be ignored during this installation.
9
Enter the protocol information. Consult your Microsoft Windows NT
4.0 documentation for help configuring the protocol.
10
When you are done, remove the floppy disk from the floppy drive.
11
Restart the system.
Note:
If you were required to insert the Windows NT CD, you
must re-install the latest version of Microsoft Windows NT
Service Pack, and then restart the system.
Duralink64 Failover for Windows NT
7-5