Creating The Failover Pair - Adaptec ANA-62000 User Manual

5
Repeat steps 1 through 4 for each existing port.
6
When you are done, click OK.
7
Continue with Creating the Failover Pair.

Creating the Failover Pair

You can create Failover pairs in the Configuration tab. A Failover
pair consists of two ports only—the primary port and the backup
port.
Windows NT 4.0
To create Failover pairs, follow these steps:
1
From the Available Adaptec Ports box, click a port to be designated
as a primary port.
Figure 7-2. Failover Configuration Tab
2
Click Add. The port is added under Primary Port in the Failover Pair
list.
3
To assign a backup to the primary port, click the appropriate port
from the Available Adaptec Ports box, and then click Add. The port
is added in the Backup Port field.
Duralink64 Failover for Windows NT
7-3