Configuring The Ports - Adaptec ANA-62000 User Manual

DuraLAN Fast Ethernet NICs User's Guide

Configuring the Ports

In the Adaptec New Hardware Found window, each port is
assigned to Autodetect, the default connection type that will always
detect port connection and negotiate a compatible speed and
transmission mode.
1
In the Adaptec New Hardware Found window, make sure all the
DuraLAN NIC ports appear.
Figure 7-1. This window identifies each port's PCI bus and PCI slot
Note:
Generally, PCI Bus 0 is the PCI Bus on the
motherboard. PCI Bus 1 or above is an ANA-62022 or
ANA-62044 NIC. The PCI Slot represents the port on the
NIC starting from the top. The top port starts at PCI Slot 4.
2
In the New Adaptec NIC Ports Available box, click the appropriate
port.
3
In the Connection Types list, click the connection type for your
network or use Autodetect Default Connection. For descriptions,
see Connection Types on page A-2.
4
Click Apply.
7-2