Verifying Configuration; Copying And Saving The Configuration - Adaptec ANA-62000 User Manual

Verifying Configuration

You should verify the current port configurations before saving
them to the server.
1
From the Main Menu, select View Configuration, and then
press Enter. The View Configuration screen appears.
Duralink Port Aggregation Setup
Interfaces Protocol
Adptsf4 P No Protocols Configured
Adptsf5 P No Protocols Configured
Adptsf6 P No Protocols Configured
Adptsf7 P No Protocols Configured
Adptsf8 P No Protocols Configured
Marcom G
IPX
Adptsf1
Adptsf2
Adptsf3
<ESC> to go back to the previous menu.
© Copyright 1998, Adaptec Inc.
Figure 11-28. View Configuration Screen
Figure 11-28 summarizes that currently five stand-alone ports
without configurations and one group named Marcom are
1
enabled. Marcom is made up of three ports: Adptsf1, Adaptsf2,
and Adapts3. The IPX protocol is assigned to Marcom using
as the frame type and 121212121 as the IPX
ETHERNET_802.2
Network Number.
2
Press Esc to return to the Main Menu.
3
Continue to Copying and Saving the Configuration.
1
If the ports or group were disabled, [Disabled] would appear next to the port/group
name.
Duralink64 Port Aggregation for NetWare
Netware Loadable Module
Frame Network
E_802.2 121212121
< F10> Abort Setup
< F1> Help
IP Address
11-15