Removing Drivers; Removing The Duralink64 Port Aggregation Driver - Adaptec ANA-62000 User Manual

Removing Drivers

The following procedures are to be used if a new driver needs to be
installed to replace an existing driver.
Removing the Duralink64 Port Aggregation
Driver
To remove the Duralink64 Port Aggregation Driver use the
following steps:
1
Insert the Duralink64 Drivers For Netware disk.
2
At the system console prompt, type load a:\nwserver\setupsf
and press Enter.
3
Select Port Aggregation from the Adaptec window.
4
In the Main Menu, select Uninstall Software, and press Enter.
5
In the Uninstall the Software box, select Yes and press Enter.
6
In the Main Menu, Press Esc to exit setupsf.
Duralink64 Port Aggregation for NetWare
11-19