Operating Modes; Control Panel; Self Control - SHOWTEC Unicorn User Manual

Operating Modes

The Unicorn has two control-modes: 1. self-control (including Master/Slave control)
1. In the self-control mode, the Unicorn has sound control and auto mode.
2. In control mode, the operator can control the X-axis, Y-axis, color, gobos, gobo rotation and shutter.

Control Panel

Below is a drawing of the control board:
When the indicator light is on, means the Unicorn is working
When you press the MODE key on the control board, then F1, F2, F3, F4, F5, F6, F7, F8, F9, FA, FB,
FC_A001 will appear on the display. When under the type of FX, press
display. Under AXXX, press
the number adds 1 to the original. Under any circumstance, press
ADDRESS settlement. The meaning of character is as follows:
F1 F2
1 Pan 1 Pan
2 Tilt 2 Pan16
3 Pan16 3 Tilt
4 Tilt16 4 Tilt16
5 Speed 5 Speed
6 Color 6 Color
7 Gobo 7 Gobo
8 Shutter 8 Shutter
*NU=Not Used
F1—F4 is the number of channels choice. If you want to set F4 to "y", F1, F2, F3 should be set to "n", at that
time, the 6 channels showing: Pan, Tilt, Color, Gobo, NU, Strobe. Any function of this product is all base on
this premise. You can consult above list to know the meaning of F5—FC.
2. control by the controller.
I ENTER,
Display
screen
Control board
ENTER
MODE
will display the number subtracts1 to the original, and press
F3 F4
1 Pan 1 Pan
2 Tilt 2 Tilt
3 Speed 3 Color
4 Color 4 Gobo
5 Gobo 5 NU
6 Shutter 6 Shutter Auto
=MODE,
UP
DOWN
will save the present FUNCTION and
F5 F6
Pan Tilt
*
F9 FA (F10)
Master
is DOWN key, is UP key.
Indicator
Fig. 7
will display, and press
F7 F8
Reset Audio
FB (F11) FC (F12)
NC Inversion
will
will display
Fig. 8
11