Setting Backlight Time; Setting Temperature Unit - TECPEL CL-327A Manual

8.2 Setting Backlight time

Step 1: Pressing the 〔START〕key ,LCD displays "BL.OFF" symbol on the upper part, indicating backlight time
setting mode.
Step 2: Set the time by using the pair of 〔〕/〔〕. And the unit is second.
Each pair of〔〕/〔〕keys corresponds to each digit of the LCD reading. Each press of the〔〕/〔〕
key increases or decreases the digit. Increasing the digit from 9 or decreasing it from 0 causes the digit to
overflow or underflow, allowing you to set the output value without interruption. Holding down the〔〕/〔〕
key continuously changes the digit . And the value won't change if it is increased or decreased to the Maxim or
Minimum value. The setting range is confined within 0-3600 seconds.
Step 3: Pressing the〔ON〕key, LCD displays "SAVE" symbol on the upper part for 1sec.
Tips:
When the default value is 0, the backlight won't be off automatically if turned on except that you turn it off
manually.

8.3 Setting temperature unit

Step 1: Pressing the〔START〕key ,LCD displays "TEM.U" symbol on the upper part, indicating temperature
unit setting mode.
Step 2: Shifting between the ℃ and ℉ by using the right pair of 〔〕/〔〕.
Step 3: Pressing the〔ON〕key, LCD displays "SAVE" symbol on the upper part for 1s.
8.4 Factory default
Step 1: Pressing the 〔START〕 key ,LCD displays "FACRY" symbol on the upper part, indicating factory default.
Step 2: Pressing the 〔ON〕 key, LCD displays "SAVE" symbol on the upper part for 1s. All settings are defaulted
32