Table of Contents
Advertisement
To avoid possible linkage of the liquid and explosion of the battery, make sure to place the battery with
right polarity.
Do not operate the battery in short-circuit.
Do not disassemble or heating the battery or
throw them into the fire
When replacing, use only four same specified
ones.
Take out the battery if you don't operate the meter
for a long time.
Step 1: Remove the test leads and Charger before
replacing batteries or fuse, and turn off the meter.
Step 2: Remove the protector as shown in Figure14.
With a standard blade hand screwdriver, turn each
battery door screw a quarter counterclockwise to
remove
Figure 14 Replacing batteries and fuses
the battery door.
Step 3:Replace with four new AAA alkaline batteries under the instructions shown on the battery door. Or
replace the blown fuses with same type F1 (50mA/250V) or F2 (63mA/250V).
Step 4:Reinstall and tighten the battery door, put on the protector before using the meter.
11 How to use the charger
39
Advertisement
Table of Contents
